1600 / 1024 / 640 - Pull-Pull and partial radio install.
1600 / 1024 / 640 - RX and Fiber Optic Extensions.
1600 / 1024 / 640 - Starting plumbing for fuel tank.
1600 / 1024 / 640 - Original linkage, plus new airfilter.
1600 / 1024 / 640 - Extra right-thrust added.
1600 / 1024 / 640 - Fender washers spread load.
1600 / 1024 / 640 - Choke servo installation.
1600 / 1024 / 640 - Ignition system installation.
1600 / 1024 / 640 - Nice clean shot for plug/sensor.
1600 / 1024 / 640 - Final cowl cutouts for clearance.
1600 / 1024 / 640 - Wingbags for the tail too.
1600 / 1024 / 640 - Troy Hamm helping with the vinyl.
1600 / 1024 / 640 - Special lettering from Kirby's.
1600 / 1024 / 640 - Holographic on the bottom,
1600 / 1024 / 640 - with vinyl stripes by Troy Hamm.
1600 / 1024 / 640 - Troy also did all of the tail.
1600 / 1024 / 640 - Factory trim doesn't include decals.
1600 / 1024 / 640 - New scale lettering from Kirby's.
1600 / 1024 / 640 - Troy's Premier Model Graphics,
1600 / 1024 / 640 - does a great job. Some trim, JR,
1600 / 1024 / 640 - and pilot name vinyl spruce it up.
1600 / 1024 / 640 - FiberOptics eliminate interference.
1600 / 1024 / 640 - Final battery home after balancing.
1600 / 1024 / 640 - redid throttle linkage with 4-40.
1600 / 1024 / 640 - Hardwood for cowl screws.
1600 / 1024 / 640 - Engine and muffler clear box.
1600 / 1024 / 640 - By about an 1/8" for muffler.
1600 / 1024 / 640 - 09/12/03 - finish graphics
1600 / 1024 / 640 - IAC logo is 4-layer vinyl graphic
1600 / 1024 / 640 - Vinyl Hitec Logo for turtledeck.
1600 / 1024 / 640 - Custom ZDZ vinyl. Fueldot for smoke.
1600 / 1024 / 640 - Applying official vinyl ZDZ logo.
1600 / 1024 / 640 - Wish it was a little smaller.
