1600 / 1024 / 640 - RCS140 left a mess to clean up
1600 / 1024 / 640 - Seeing how ZDZ40 fit.
1600 / 1024 / 640 - Mounted!
1600 / 1024 / 640 -
1600 / 1024 / 640 - Decent fit, a little tall.
1600 / 1024 / 640 - Had to trim one cowl block.
1600 / 1024 / 640 - Sparkplug sticks out a little
1600 / 1024 / 640 - Had to replace ruined covering.
1600 / 1024 / 640 - Prop installed! (ignore my mess!)
1600 / 1024 / 640 - Refit the cowl, drill new holes.
1600 / 1024 / 640 - Throttle and Choke linkages.
1600 / 1024 / 640 - manual choke this time.
1600 / 1024 / 640 - Covering replaced and Ply...
1600 / 1024 / 640 - added for transport supports
1600 / 1024 / 640 - Remove Choke servo, reinstall tank.
1600 / 1024 / 640 - painted choke lever.
1600 / 1024 / 640 - Added straws to access needles.
1600 / 1024 / 640 - no removing cowl for carb adjust!
1600 / 1024 / 640 - Test fit dummy radial, may replace.
1600 / 1024 / 640 - Mount igntion and battery.
1600 / 1024 / 640 - Cowl mounted!
1600 / 1024 / 640 - Install Propeller
1600 / 1024 / 640 - 4.5" ground clearance with 20x10
1600 / 1024 / 640 - Just about Ready!
1600 / 1024 / 640 - Test balance.
1600 / 1024 / 640 - Out at field testing engine.
1600 / 1024 / 640 - won't run right...
1600 / 1024 / 640 - back home to find out why.
1600 / 1024 / 640 - Won't draw fuel very well...
1600 / 1024 / 640 - carb installed wrong???
1600 / 1024 / 640 - port is open to air,
1600 / 1024 / 640 - surprised it ran at all.
1600 / 1024 / 640 - Reinstall seemingly correctly.
1600 / 1024 / 640 - Put engine back on mount.
1600 / 1024 / 640 - Re-plumbed the fuel tank,
1600 / 1024 / 640 - just for good measure.
1600 / 1024 / 640 - battery back as far as reachable.
1600 / 1024 / 640 - and still needed 2.5oz...
1600 / 1024 / 640 - in the tail to balance! :-(
1600 / 1024 / 640 - 04/16/03
1600 / 1024 / 640 -
1600 / 1024 / 640 -
