1600 / 1024 / 640 - First repair... separating "ply".
1600 / 1024 / 640 - F3 former 3-layer balsa, needed help.
1600 / 1024 / 640 - Landing gear plate, good quality here.
1600 / 1024 / 640 - Firewall, all ok here.
1600 / 1024 / 640 - Landing gear cover temp installed.
1600 / 1024 / 640 - Inside toward firewall.
1600 / 1024 / 640 - Radio Tray and Wing bolt area.
1600 / 1024 / 640 - Looking toward tail, all looks good.
1600 / 1024 / 640 - Other than F3, quality wood used.
1600 / 1024 / 640 - Fuse out of package.
1600 / 1024 / 640 - Good covering job.
1600 / 1024 / 640 - First real concern, stab opening.
1600 / 1024 / 640 - Not a good contact area.
1600 / 1024 / 640 - Bellcrank and servo holes under cover.
1600 / 1024 / 640 - Bellcrank has access port.
1600 / 1024 / 640 - Fiberglass paint is good match for ultracote.
1600 / 1024 / 640 - Black, Flame Red, Bright Yellow Ultracote
1600 / 1024 / 640 - All White with 2" black squares applied.
1600 / 1024 / 640 - Crazy throws available on Elevator!
1600 / 1024 / 640 - Rudder is stick built, but all black.
1600 / 1024 / 640 - Looks good... will get a club decal.
1600 / 1024 / 640 - Glad they left the decals to use or not.
1600 / 1024 / 640 - Top of wing.
1600 / 1024 / 640 - Bottom. 4" Black squares over white.
1600 / 1024 / 640 - Left wing panel structure.
1600 / 1024 / 640 - Right wing panel structure.
1600 / 1024 / 640 - Wing dowl.
1600 / 1024 / 640 - Front view.
1600 / 1024 / 640 - Wheel pant. Also good quality.
1600 / 1024 / 640 - Block built in; will open up some more.
1600 / 1024 / 640 - Stab in fuse, light shows the gap.
1600 / 1024 / 640 - I'll have to figure out a way to fix.
1600 / 1024 / 640 - Fuse markings from shipping.
