1600 / 1024 / 640 - Radio gear on its tray.
1600 / 1024 / 640 - Blue thing is fiber-optic killswitch.
1600 / 1024 / 640 - Fit cowl and trim for exhaust.
1600 / 1024 / 640 - Only a bit of pipe sticks out.
1600 / 1024 / 640 - Start ignition system install.
1600 / 1024 / 640 - Lots of room to neatly install.
1600 / 1024 / 640 - battery on top (fuse is upside down).
1600 / 1024 / 640 - Fiber-optic kill switch.
1600 / 1024 / 640 - Cowl cut for engine cooling.
1600 / 1024 / 640 - Red LED on when ignition is on.
1600 / 1024 / 640 - Perfectly placed cooling tunnel.
1600 / 1024 / 640 - RX tray, servo rails w/RX battery.
1600 / 1024 / 640 - 16oz boat gas tank back on CG.
1600 / 1024 / 640 - Tank's view of firewall.
1600 / 1024 / 640 - Room for two, if desired (smoke?)
1600 / 1024 / 640 - Barcoded piece added for strength.
1600 / 1024 / 640 - Fuel Dot in scale location.
1600 / 1024 / 640 - Dots from www.PSPmfg.com
1600 / 1024 / 640 - I'm terrible with decals...
1600 / 1024 / 640 - so I made a balsa back for it.
1600 / 1024 / 640 - Much easier to position this way!
1600 / 1024 / 640 - Trial fit the windshield.
1600 / 1024 / 640 - Time to take it outside...
1600 / 1024 / 640 - for its first taste of sunshine!
1600 / 1024 / 640 - Nearly completed. Still waiting...
1600 / 1024 / 640 - on some orders so I can finish.
1600 / 1024 / 640 - Back inside to test-fit struts.
1600 / 1024 / 640 - Install tank. Tygon is vent/overfill.
1600 / 1024 / 640 - Black wire is Fiber-Optic cable.
1600 / 1024 / 640 - Finish plumbing and connect servos.
