2272 / 1024 / 640 - RX Switch install.
2272 / 1024 / 640 - LED/Charge Switch from MPI.
2272 / 1024 / 640 - Use servo to mark.
2272 / 1024 / 640 - Drill here. :-)
2272 / 1024 / 640 - Not too deep on screws. :-(
2272 / 1024 / 640 - Install aileron servo.
2272 / 1024 / 640 - Setup linkages.
2272 / 1024 / 640 -
2272 / 1024 / 640 - Both ailerons done.
2272 / 1024 / 640 - Back of horn closeup.
2272 / 1024 / 640 - good throws on aileron. :-)
2272 / 1024 / 640 - Good throws on elevator too.
2272 / 1024 / 640 - Hardware used for gear.
2272 / 1024 / 640 - Install wire into mount.
2272 / 1024 / 640 - Note proper orientation. ;-)
2272 / 1024 / 640 - Opened holes.
2272 / 1024 / 640 - White block holds them in.
2272 / 1024 / 640 - Now tighten them down.
2272 / 1024 / 640 - Grind flat spot on axle.
2272 / 1024 / 640 - Blue locktite on collar set screw.
2272 / 1024 / 640 - Landing gear all done!
2272 / 1024 / 640 - Swany method for throttle.
2272 / 1024 / 640 -
2272 / 1024 / 640 - Installed at best angle.
2272 / 1024 / 640 - Held motor up for alignment.
2272 / 1024 / 640 -
2272 / 1024 / 640 - Cleaned up the radio bay.
2272 / 1024 / 640 - 5-cell 1650mah RX battery.
2272 / 1024 / 640 - Will fill with foam before closing.
2272 / 1024 / 640 - Mark and drill engine holes.
2272 / 1024 / 640 - Saito 72 Mounted!
2272 / 1024 / 640 - 4-40 stainless hardware.
2272 / 1024 / 640 - Used thrust-wedgies from Swany.
2272 / 1024 / 640 - Finish up throttle servo.
2272 / 1024 / 640 -
2272 / 1024 / 640 -
2272 / 1024 / 640 - Plumbed and installed tank.
2272 / 1024 / 640 -
2272 / 1024 / 640 - Ran breather down gear leg.
2272 / 1024 / 640 - Dumps out on ground.
2272 / 1024 / 640 -
2272 / 1024 / 640 - Install hatches.
2272 / 1024 / 640 -
2272 / 1024 / 640 - READY TO FLY!
